2
Getting Started
Your Treasure Commander TC3X comes complete and ready to use. The first step is to
unpack the box and check to make sure you have all the items needed to quickly
assemble the detector. You should find the following parts inside the box:
•
Handle Unit with Arm Cuff and Stand
•
Top Rod with Locking Collar
•
Bottom Rod
•
Search Coil with Bolt Assembly
•
Cable Pulling Tool
•
Operator Instruction Manual
•
Warranty Card
If any of these items are missing, contact Kellyco Detectors immediately. It is
recommended that you make a record of your detector's serial number and store it along
with your proof of purchase in a safe place in case you ever need this information for
warranty service.
Assembly
Assembly of your new Treasure Commander TC3X is very simple and requires no special
tools.
1
Connect the Search Coil and Bottom Rod:
Unscrew the bracket from the bottom rod as it comes
shipped from the factory. Place the bottom rod inside
the tabs on the search coil and insert the bolt through
the hole. Tighten the bolt until snug but take care not
to over tighten it as you can damage the coil or the
bolt.
NOTE: The large hole in the end of the bottom rod
must be facing downwards - this is where the search coil cable will enter the rod and be
fed upwards to connect into the control housing.
2
Connect the Bottom and Top Rods:
Loosen the locking collar on the top rod (do not
Summary of Contents for TC3X
Page 1: ......
