7
IRON segment. NOTE: Ground mineralization, trash or nearby electrical
interference can require a lower Sensitivity level to be selected. Sensitivity range
can be adjusted for 1 to 8. Volume: The selected volume level is indicated by the
number to the right of the Sensitivity setting. CAUTION: If you are using
headphones that do not have a built-in volume control, it is recommended that you
set the Volume level at a low value before plugging the headphones in. Adjust the
volume to a comfortable level by sweeping the coil across a target. The Volume
level can be adjusted from 1 to 4.
•
Depth: When a target is detected, the target’s approximate depth will be
displayed in inches on the right side of the LCD next to the QUARTER segment.
•
NOTE: This indication assumes the target is coin-sized so a larger target will
appear to be shallower that it really is and a smaller target will appear deeper than
it really is. Use this as a guide to avoid damaging targets when recovering them
but recognize that the accuracy depends on the size of the target.
•
Factory Preset Detect Modes and Discrimination / Notch Modes: The upper
left area of the LCD screen will indicate which mode you are in as well as when
searching, which of the three (3) factory Preset programs are active. Same is true
for the two (2) Custom Discrim and Notch programmable modes.
•
Signal Strength: Located just beneath the P-TAB / S-CAP segments, this icon will
provide indication of how strong the signal from a detected target is when the
Pinpoint trigger is activated. Combined with the Depth indication, the Signal
Strength indication can help you determine the relative size and depth of a target
before you recover it.
•
Identification: Located in the center of the LCD screen, this will provide an 8-digit
identifier active when one of the five (5) Detecting Modes or the GPS function is
selected.
Summary of Contents for TC3X
Page 1: ......
