Treasure Cove TC2X, Operating Manual

Page: 10 / 24

7
value before plugging the headphones in. Adjust the volume to a comfortable level
by sweeping the coil across a target. The default factory value is "4".
 Depth : When a target is detected and th e Pinpoint mode is activated, the target’s
approximate depth will be displayed in inches on the right side of the LCD next to
the QUARTER segment.
NOTE : This indication assumes the target is coin-sized so
a larger target will appear to be shallower that it really is and a smaller target will
appear deeper than it really is. Use this as a guide to avoid damaging targets when
recovering them but recognize that the accuracy depends on the size of the target.
 Settings / Detect Modes and Discrimination / Notch Modes : The lower area
of the LCD screen will indicate which mode you are in as well as when searching,
which of the four (4) discrimination programs are active.
 Signal Strength : Located just beneath the P-TAB / S-CAP segments, this icon will
provide indication of how strong the signal from a detected target is. Combined
with the Depth indication, the Signal Strength indication can help you determine
the relative size and depth of a target before you recover it.
 Identification : Located in the center of the LCD screen, this will provide an 8-digit
identifier active when the GPS function is selected. It will be covered in more detail
later in the manual.
Touchpad Operation
While the Treasure Commander TC2X offers a high level of performance under a wide
range of conditions, all of its functions are controlled through the use of just seven (7)
touchpads. The four (4) touchpads located around the ENTER touchpad serve dual
functions; i.e., they allow you to navigate through and adjust specific features when in the
SETTINGS mode and activate specific functions when used by themselves.