·
Arm Support---
lets you carry and operate your detector comfortably.
·
Power---
Your metal detector requires two 9-volt alkaline batteries (not supplied).
The built in insolating circuit can avoid wrong battery connection and prolong
the battery life.
PREPARATION
ASSEMBLING THE DETECTOR
Assembling your detector is easy and requires no special tools. Just follow these
steps:
1. Insert the latch on the liner into the assembly hole on the bottom of the control
box. Then slightly push the control box in the direction of IN on the handle to
fix the latch in place. Tighten the fixing screw properly.
fixing screw
latch
liner
control box
assembly hole
2. Unscrew the knobs on the search coil, then remove the knobs and the
connector. Insert the stem and align the holes on the search coil bracket and
the stem. Push the connector through the holes, then replace and tighten the
knobs.
3. Wind the search coil cable around the stem and insert its plug into the relevant
jack.
3
