2
1
Status LED and Power Switch
(switch located on rear)
2
Input clip LED
– Channel 1-3
3
Channel 1 Input Jacks
– ¼-inch TRS jacks
4
Channel 1 Gain Control
5
Channel 1 Tone Controls
– Bass and Treble
6
Channel 2 Input Jacks
– Balanced XLR and ¼-inch TRS jacks
7
Channel 2 Gain Control
8
Channel 2 Tone Controls
– Bass and Treble
9
Channel 3 Input Jacks
– ¼-inch and jacks
10
Channel 3 Gain Control
11
Channel 4 Input Jack
– ¼-inch TRS jack
12
Channel 4 Gain Control
13
Master Volume Control
14
Headphones Jack
– ¼-inch TRS jack
15
Link Pan / Balance Control
16
Line Out
– Balanced XLR jack, Pre/Post Selector and Ground Lift
17
Link Jacks
Power
1. Power/Status LED
The power LED displays the status and condition of the amplifier. When powering up the
Traynor Block amplifier, the LED will illuminate red for a few moments and then turn blue
when the amp is ready to go. If a fault is detected, the LED will constantly illuminate red.
Input Channels
2. Input clip LED
The input clip LED located near the Power/Status LED, has been designed to monitor Chan
-
nels 1-3 for clipping. It will turn on when the input signal from an audio source is too hot (or
the gain is set too high). Adjust the channels individually while playing until the LED stops in
-
dicating clipping (it’s okay if the LED blinks briefly).
9
3
8
14
5
6
11
16
12
1
2
4
7
10
15
17
13