Traynor Acoustic Master AM50T, Owner'S Manual, Page: 4 / 10

ACOUSTIC MASTER
R
ing/
S
leeve, +/-/gnd). The ¼-inch phone jack can also
accept regular unbalanced cables. For best results, and
to reduce noise, it is advised that you use balanced
(stereo) cables for interconnection wherever possible.
Do not use both the phone and XLR inputs at the same time
(signals will be highly attenuated).
Line Out
The Line Out is post channel 1 and 2, as well as pre-
effects. This means the Gain controls do affect the
output to the Balanced Line Out and there is no reverb
effect. The Line Out can be connected directly to a mixer
or even another amplifier. The soundman can then add
reverb on the mixer if required.
Reverb Level Control
The AM50T uses a mechanical spring reverb tank
that is adjustable using the
Reverb
level control. The
Reverb level control affects the amount of reverb for
both channels. When the level control is rotated fully
clockwise, your signal will be wet (utilizing the maximum
amount of reverb available). Conversely, if the level
control is rotated fully counter-clockwise the reverb will
be totally defeated (off).
Specifications
Power @ min. impedance (Watts) 50
Minimum Impedance (ohms)
8
Burst Power - 2 cycle 70 Watts
Speaker Configuration - LF (Size / Power)
8 inch / 50 Watts
Speaker Configuration - HF (Size / Power) 3.75 inch / 30 Watts
Input Channels
2
Channel 1 - inputs 1/4 inch TRS
Channel 1 - controls Gain, Low, High, Frequency Notch Filter
Channel 1 - switches Frequency Notch Filter Defeat
Channel 2 - inputs 1/4 inch TRS, XLR
Channel 2 - controls Gain
Input Sensitivity (mV) ch 1=100, ch 2=1V
Line Out (type / configuration)
1/4 inch TRS
Line Out Sensitivity (Vrms) 1
Effects Volume
Yes
Effects Loop / Location No
Internal Reverb / Effects
Spring Reverb
LED Indicators Power, Clip
Dimensions (DWH, inches)
14 x 12 x 17
Dimensions (DWH, cm) 36 x 30 x 43
Weight (lbs / kg) 23.5 / 10.7