Slash
•
7
Quick Start: Getting up to Speed
The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom
corners of Quick Start pages.
1. Read the safety precautions on page 4
7. Check servo operation • See page 14
For your own safety, understand where carelessness and misuse
could lead to personal injury.
Make sure the steering servo is working correctly.
2. Charge the battery pack • See sidebar, page 10
8. Range test the radio system • See page 14
Fully charge a 7.2-volt battery pack (not included). Charge your battery
now so it will be ready when you finish the other setup procedures.
Follow this procedure to make sure your radio system works properly
at a distance and that there is no interference from outside sources.
3. Install the antenna • See page 12
9. Detail your model • See page 8
Install the antenna mast in the model.
Apply other decals if desired.
4. Install batteries in the transmitter • See page 11
10. Drive your model • See page 17
The transmitter requires 8 AA alkaline or rechargeable batteries.
Driving tips and adjustments for your model.
5. Install battery pack in the model • See page 11
11. Maintaining your model • See page 22
Your model requires a fully charged 7.2-volt battery pack
(not included).
Follow these critical steps to maintain the performance
of your model and keep it in excellent running condition.
6. Turn on the radio system • See page 14
Make a habit of turning the transmitter on first, and off last.
The Quick Start Guide is
not intended to replace the
full operating instructions
available in this manual.
Please read this entire
manual for complete
instructions on the proper
use and maintenance of
your model.
Look for the Quick Start
logo at the bottom of
Quick Start pages.
