SP1
136
1-R
00
Mad
e in
Ch
ina
R
X
1200MAH
6V NiMH
PART
# 3036
* Not used
Steering Servo
-
CH1
Steering Servo
-
CH1
OptiDrive Throttle
-
CH2
OptiDrive Shift
-
CH3
From Voltage/Temp Senor Port
-
CH4
Battery
-
BATT/CH5
RPM Sensor Port
-
RPM
Voltage/Temp Senor Port
-
V/T
Steering Servo
-
CH1
Steering Servo
-
CH1
OptiDrive Throttle
-
CH2
OptiDrive Shift
-
CH3
From Voltage/Temp Senor Port
-
CH4
Battery
-
BATT/CH5
RPM Sensor Port
-
RPM
Voltage/Temp Senor Port
-
V/T
REVO 3.3 • 9
REVO WIRING DIAGRAM
Antenna
On/Off
Switch
Receiver
RX Power Pack
5-cell NiMH
Battery
Steering
Servos
Throttle Servo
Shifting Servo
(micro servo)
OptiDrive ESM
(Electronic Shift
Module)
Charging Jack
(to charger)
To Transmission
(OptiDrive sensor)
Your Revo is equipped with the TQi radio system. The TQi is a 3-channel system that provides control for up to three outputs. Revo is equipped with two
high-torque steering servos connected via dual Channel 1 outputs. The TQi works in conjunction with the OptiDrive
®
Electronic Shift Module to monitor and
control the input and output signals for the throttle and shifting servos (channels). The OptiDrive monitors the voltage of the on-board RX Power Pack. The
“Function” LED will flash red if the battery voltage is too low.
If the power indicator doesn’t
light green, check the polarity
of the batteries. Check
rechargeable batteries for
a full charge. If you see any
other flashing signal from the
LED, refer to the chart on page
44 to identify the code.
When rechargeable batteries
begin to lose their charge,
they will fade much faster
than alkaline dry cells. Stop
immediately at the first sign
of weak batteries. Never turn
the transmitter off when the
battery pack is plugged
in. The model could run out
of control.
TRAXXAS TQ
i
RADIO SYSTEM
TRAXXAS TQ
i
RADIO SYSTEM
TRANSMITTER AND RECEIVER
Steering
Trim
Shift
Switch
Throttle
Trigger
Multi-Function
Knob
Throttle Neutral
Adjust
Steering Wheel
Power Switch
Battery Compartment
Traxxas Link
Wireless Module
Set Button
Menu Button
Red/Green Status LED
see page 44 for more info
Link
Button
LED
Sensor Expansion
Port
Temp
Sensor
Voltage Sensor
RPM Sensor
Telemetry
Voltage Wire
Connects the V/T
port to any open
receiver port.
