2
1
3
4
OPERATION
Mode Selection
The LED lights will turn on when the electronic control module (ECM) is powered on by plugging in the battery. Press and release the
EZ-Set button
on
the ECM to toggle through the different lighting modes. The chart below indicates how the lights will function in each mode:
WIRING DIAGRAM
BODY UNDERSIDE VIEW
Warranty Information
Traxxas electronic components are warranted to be free from defects in materials
and workmanship for a period of 30 days from the date of purchase.
Limitations:
Any and all warranty coverage does not cover replacement of
parts and components damaged by abuse, neglect, improper or unreasonable
use, crash damage, water or excessive moisture, chemical damage, improper or
infrequent maintenance, accident, unauthorized alteration or modification or items
that are considered consumable. Traxxas will not pay for the cost of shipping or
transportation of a defective component to us.
Land Rover® and Defender® are trademarks of Jaguar Land Rover Limited.
All copyrights and trademarks are used by Traxxas under license.
Traxxas Lifetime Electronics Warranty
After the expiration date of the warranty period, Traxxas will repair electronic
components for a flat rate. The covered repairs are limited to non-mechanical
components that have NOT been subjected to abuse, misuse, or neglect. Products
damaged by intentional abuse, misuse, or neglect may be subject to additional
charges. Traxxas liability, in no case, shall be greater than the actual purchase price
of this product. For replacement, product must be returned in brand new condition,
with packaging and itemized sales receipt.
TRAXXAS.com
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: [email protected]
Route tail light harness
under rear cross brace
Use zip ties to secure all wiring to the body in the locations shown.
WARRANTY
Mode Selection
Action
1
Headlights, daytime running lights, and tail lights on; brake lights on when braking; reverse lights on
when reversing
Default
2
Headlights off; daytime running lights and tail lights on; brake lights on when braking; reverse lights on
when reversing
Press and release EZ-Set button on ECM once
3
Headlights, daytime running lights, and tail lights off; brake lights on when braking; reverse lights on
when reversing
Press and release EZ-Set button on ECM 2x
4
Hazard lights on; headlights, daytime running lights, and tail lights off; brake lights on when braking;
reverse lights on when reversing
Press and release EZ-Set button on ECM 3x
5
LED lights display (demo mode, sequence of all lighting) (truck will not drive in this mode)
Press and release EZ-Set button on ECM 4x
To reset back to the default mode and settings, unplug the battery from the ECM and start over.
