IMPORTANT:
Always turn the transmitter on first, before you connect the
battery pack in your electric model. If you do not, the model
will operate erratically and appear to malfunction.
(Remember, the transmitter is on first and off last.)
PRECAUTIONS:
• Excessive heat is the main enemy to your speed control. Excessive
heat, which is built up from the improper installation and use of an
electronic speed control is the number one cause of failure. By being
attentive to the performance and care of your model, you can be
assured trouble-free operation.
• Do not overload your speed control. The harder your motor has to work,
the more current (amps) is drawn through the speed control. As the
current draw increases, so does the heat built-up. Here are some tips to
prevent overloading your BXL-1.
• Be sure that your model is not over-geared. Symptoms of over-gearing
include an extremely hot motor, hot batteries, short run time, an
extremely hot speed control, and sluggish acceleration. If you
experience any of these symptoms, try using a smaller pinion gear on
the motor. The other danger of being over-geared is that it can lead to
premature motor failure. When an overworked motor fails, it can
become a short circuit and severely damage your BXL-1.
• If your model encounters an obstacle which it cannot pass, or becomes
trapped in deep sand, do not continue to run the model. This will
prevent damage to the motor and speed control. Return the transmitter
controls to their neutral position and then free the model.
• Get into the habit of periodically checking the temperature of your
electronic components. If any of them are too hot to touch, especially
the speed control, do not continue to run your model. Wait a few
minutes for everything to cool down before continuing.
• The radio system is not waterproof. Avoid driving through puddles, wet
grass, or mud.
For marine applications, protect the speed control
from submersion or standing water inside the boat. If water gets
into the electronics, it could damage them.
• Do not continue to operate the model with low batteries or you could
lose control of it. Indications of low battery power include: slow
operation, sluggish servos, and, for Traxxas transmitters, a flashing red
light. When using nicad batteries, be especially alert for signs of weak
batteries. Stop immediately at the first sign of weak batteries.
• Do not use modified motors with fewer than 18-turns of wire with the
BXL-1 speed control. More powerful motors increase current flow through
the electronics and could damage them. When using high-performance
motors, make sure that cooling air can pass over the heat sinks.
• Allow the speed control to cool down between battery packs to ensure
correct operation and long life.
LIMITED ELECTRONICS WARRANTY:
TRAXXAS CORPORATION warrants your TRAXXAS electronic product to
be free from defects in materials or workmanship for a period of
thirty
(30) days
from the date of purchase. During the warranty period, please
send the defective unit, along with your proof of purchase indicating the
date purchased, your return address, a daytime phone number, and a
brief description of the problem to:
TRAXXAS CORPORATION
1100 Klein RD.
Plano, TX 75074
If the component is found to be defective, it will be repaired or replaced
at no charge.
THIS WARRANTY DOES NOT COVER DAMAGE DUE TO
CARELESSNESS, MISUSE, NEGLECT OR ABUSE.
TRAXXAS makes no other
warranties, expressed or implied. TRAXXAS shall not be liable for any
indirect, incidental, or consequential damages arising out of the
assembly, installation, or use of this product.
This warranty gives you specific legal rights and you may also have
other rights which vary from state to state. You are required to complete
and return the enclosed REGISTRATION CARD as a condition of the
coverage and performance of this warranty.
THE TRAXXAS EXTENDED SERVICE PLAN
FOR ELECTRONIC COMPONENTS
After the expiration date of the warranty period, TRAXXAS will repair
electronic components for a flat rate of $15.00 plus $5.00 for shipping
and handling. The products covered by this extended service plan
include electronic speed controls, transmitters, receivers, servos and
battery chargers. Motors and mechanical speed controls are not covered.
Other mechanical repairs will be estimated on an individual basis. The
covered repairs are limited to non-mechanical components which have
not been subjected to abuse, misuse, or neglect. The separate enclosed
form must be filled out completely and enclosed along with the product
to be repaired.
Return the unit(s) with a brief note describing the problem, plus a
daytime phone number and return address to
:
TRAXXAS
1100 Klein RD.
Plano, TX 75074
For technical assistance, call 1-888-TRAXXAS
For orders & other information, call 972
-265-8000
www.Traxxas.com
E-mail: [email protected]
REV
030109
