R16 High Frequency Ring Saw & P8000 Power Converter
Operations Manual | 16
MAINTENANCE AND CLEANING
This machine operates in a very harsh environment.
Therefore, it’s essential for the long life of the tool that it be thoroughly cleaned after each use.
Daily Maintenance
1.
Keep the machine clean
2.
Check to ensure that the motor coupling cable, power supply cables and water coupling hoses are in
good condition.
3.
Ensure all screws are tight.
4.
Check the condition of all safety equipment such as the blade guard
5.
Check the blade for damage.
6.
Ensure that the guide tensioners and drive tensioner are properly adjusted.
If the replacement of the power supply cord is necessary, this has to be done by the manufacturer or their
agent in order to avoid a safety hazard.
WARNING: All repairs must be entrusted to an authorized service center. Incorrectly performed repairs
could lead to injury or death.
Do not throw electric power tools into the household waste!
In accordance with the European Directive 2002/96/EG on Waste Electrical and Electronic Equipment and
transposition into national law, used electric power tools must be collected separately and recycled in an
environmentally friendly manner.
E12
Poor connections of power
supply cable –three phase
Check the connections of the power supply plug and cable
E15
Internal problem in the
converter electronics board
circuit
At the converter, try pressing the POWER button to turn the
power OFF and then back ON again (If the problem persists,
bring the unit to an authorized
service center for repair)
E16
No signal from the motor
temperature sensor
At the tool, try turning the switch OFF and then ON again (If
the problem persists, bring the unit to an authorized service
center for repair)
E17
Motor temperature sensor short
circuited
At the tool, try turning the switch OFF and then ON again (If
the problem persists, bring the unit to an authorized service
center for repair)
