Media Tube
®
HO
Mounting Guide
www.traxontechnologies.com
©2022 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE
WITHOUT NOTICE.
Mounting Guide
02/22 V0.8
1 of 2
Tube-to-Tube Clearance
To maintain consistent LED pitch and to
allow for thermal expansion for Media Tubes.
See DETAIL A
See DETAIL B
Diffused Tube
Pour maintenir le pas constant entre
les LEDs et absorber la dilatation
thermique des Media Tubes.
Connector End Cap
TU.AC.0600000
End Cap Seal on Last Tube
DETAIL A
DETAIL B
69mm / 2.7”
109mm / 4.3”
23mm / 0.9”
51.5mm / 2”
24mm / 0.94”
36mm / 1.4”
296mm, 596mm, 896mm, 1196mm, 1496mm / 11.7”, 23.5”, 35.3”, 47.1”, 58.9”
81mm / 3.2”
29mm / 1.14”
Direct View Tube
54mm / 2.1”
Mounting
296mm, 596mm, 896mm, 1196mm, 1496mm / 11.7”, 23.5”, 35.3”, 47.1”, 58.9”
182mm / 7.2”
>4mm/0.16”
M6 x 23mm
Use Rear Studs For Alternative Mounting
Utiliser les goujons taraudés pour un montage différent
Loosen mounting stud may lead to
water ingression into Media Tube.
Ne pas desserrer les goujons taraudés
sous perte d’étanchéité du Media Tube.
81mm / 3.2”
30mm / 1.2”
33mm / 1.3”
29mm / 1.14”
63mm / 2.5”
30mm / 1.2”
33mm / 1.3”
TAK!
Bouchon d’étanchéité à
monter sur le dernier tube
IMPORTANT NOTE:
If no “Tak!” sound is heard or connector still not mated
well, push both connectors inwards and manually rotate
spring head of male connector in the locking direction.
Connect
1. By pushing the cable connectors inwards, quick lock
connectors shall be mated and locked automatically.
2. Locking requirement of the quick lock connectors after mated:
• “Tak!” sound should be heard
• All 3 arrows should be in one straight line
• Connector cannot be pull out
TAK! and lock
Wrapping
3. Wrap female and male connector as well as end cap with 3M
Scotch Rubber Splicing Tape 23 (or other similar self-
amalgamating rubber tape) for secondary protection in the
direction opposite to the unlocking direction.
Water-proof
4. 3M Scotch
®
Rubber Splicing Tape 23* should be applied in
successive half-lapped, level-wound layers until desired buildup is
reached.
*For details, refer to the 3M Scotch
®
Rubber Splicing Tape 23 Data Sheet.
1~1.2Nm
1~1.2Nm
The Max. projected area: 0.081m
2
