Page 10
INSERT OPTIONAL EQUIPMENT (Continued)
2. Surround Panel Brass Trim (Included with Surround Panels)
The surround panel brass trim is an item included with your panels that greatly enhances the appearance
of your insert and is easy to install.
1.
Lay the three pieces of brass trim on the floor in front of the insert. Arrange the brass trim so that it
resembles the illustration below. The rounded edge of the trim that will be facing outwards when
installed should be facing down.
Lay the trim on the floor in
front of the insert with the
rounded portion facing down.
Insert
CROSS SECTION OF BRASS TRIM
Set-screw that
holds the larger "L"
bracket in place
Groove where the
larger "L" bracket
fits into
Groove Where
Surround Panels
Slide
Groove where the
smaller "L" bracket
fits into
Front Side
Larger "L"
Brackets
Top Trim
Left Trim
Right Trim
Smaller "L"
Brackets
2.
Insert a large and small "L" bracket leg into the groove in the 45
o
cut end of each side piece. Slide the
other leg of each "L" bracket into the groove in each end of the top piece.
3.
With the allen wrench included with the trim, tighten the set-screws into the "L" brackets, insuring that
the 45
o
cuts are butted together to form a neat joint.
4.
Lift the complete brass trim assembly and slide the side pieces down over the edge of the side panels
until the bottom edge of the brass trim is flush with the bottom of the side panels and the top panel is
in the groove of the top brass trim piece.
3. Bay Kit
The bay kit for your insert is sold separately and offers an attractive facade for your installation. It is very
important that your installation is adequately suited for the bay kit before deciding on that type of
installation. For direct or positive connections the bay kit does not require insulation for an airtight seal.
For face seal connections the bay kit must overlap the fireplace at least 2" on the top and sides and
requires insulation to insure an airtight seal (See "Surround Panel Insulation Installation").
BAY KIT DIMENSIONS:
37" Wide
28" Height
NOTE: For a Face Seal Connection it is recommended that you have at least 2" of
overlap. On brick or stone facing an overlap of 2 1/2" may be necessary for an airtight
seal due to the rough surface.
It is very important that the bay kit overlaps the fireplace opening by 1/4" or more. This will insure a good
seal and provide a more attractive facade. The bay kit must overlap the fireplace opening in both width
and
height. The bay kit may overlap the fireplace opening by more than the 1/4" recommendation if it is
to allow for a complete seal. Any questions on the use of the bay kit should be directed towards your
dealer. To install the bay kit, first refer to the type of installation you are using (e.g. Face Seal Connection,
Direct Connection, etc...).
