Traulsen UHT Series, Owner'S Manual

Page: 4 / 14

III. h - CUTTING BOARD ASSEMBLY-UPT/UST:
On sandwich prep tables, the cutting board may require assembly at
the site.
Place cutting board on cabinet, properly align & install three screws to
secure in place. The cutting board is field reversible, reverse process
to reverse cutting board.
Note: The lid(s)/cover(s) are installed at the factory. No assembly
required.
III. INSTALLATION (continued)
III. d - SHELF CLIPS FOR DOOR MODELS:
Shelves and shelf clips are shipped with the unit. For each shelf, insert four (4)
shelf clips into the pilaster slots at the same height. The shelf clips have a small
projection on top which holds the shelf position and prevents it from slipping
forwards. After installing shelf clips on pilasters, place shelves on clips.
III. e - CORD & PLUG:
All UHT, ULT, UPT & UST models are supplied with a cord and plug attached. It
is shipped coiled at the bottom of the cabinet, secured by a nylon strip. For your
safety and protection, all units supplied with a cord and plug include a special
three-prong grounding plug on the service cord. Select only a dedicated electrical
outlet with grounding plug for power source.
NOTE: Do not under any circumstances, cut or remove the round grounding
prong from the plug, or use an extension cord.
III. f - POWER SUPPLY:
The supply voltage should be checked prior to connection to be certain that proper
voltage for the cabinet wiring is available (refer to the serial tag to determine correct
unit voltage, see page 1). Make connections in accordance with local electrical
codes. Use qualified electricians.
Use of a separate, dedicated circuit is required. Size wiring to handle indicated
load and provide necessary over current protector in circuit (see amperage require -
ments on the unit’s serial tag).
III. g - CLEARANCE:
It is important for the proper operation and longevity of your Traulsen unit that it
have adequate provisions underneath for air supply to the compressor. There are
no clearance requirements for the sides, rear or top.
NOTE: Do not install the cabinet without legs, casters or a front ventilated
utility base.
III. INSTALLATION (continued)
-3-