INTERNALLY ROUTED DROPPER POST AND 1X LEVER
1X LEVER INSTALLATION
Position hinged clamp on bar and attach
lever to clamp using either threaded hole
on lever body to best fit your hand. Tighten
with 4mm Allen wrench to maximum 4Nm.
NOTE: This position can be changed after
install to fine tune fit.
1
3
Pull cable tight and tighten cable
fixing bolt to 2Nm with a 3mm
Allen wrench.
5
Trim excess cable with cable cutters leaving
enough room to install the cable end,
approximately 10mm. It is important to use
proper cable cutters to prevent the cable from
fraying. Crimp cable end in place.
4
Push the lever 5-10 times to make sure the cable housing is fully
seated and to check for play in the cable. NOTE: If there is play in
the lever/cable, loosen cable fixing bolt with 3mm Allen wrench
and pull cable tight a second time. For micro adjustment, use the
barrel adjust on the lever where the cable enters.
Loosen but do not remove the cable fixing bolt on
the underside of the dropper lever with a 3mm
Allen wrench, screw the barrel adjuster fully in
clockwise, and make sure the cable housing has a
housing end installed. Insert the dropper cable
through the barrel adjuster until the housing is
completely seated in barrel adjuster, threading the
cable under the cable fixing bolt and washer.
2
