S4.4 BELTPACK LAYOUT
BELTPACK BATTERY INSERTION
1. Slide the battery compartment to the rear and hinge up-wards to expose
the battery.
2. Insert a 9V MN1604 (IEC 6 LR61) PP3 type alkaline battery, being sure to
observe the correct polarity as marked.
Note
: Should the Red battery status Led Indicator go out during operation, this
indicates a flattened battery and should be changed .
MICROPHONE CONNECTION
1. Connect small lapel-type microphone into the corresponding 3.5mm Top
Panel Socket.
2. Ensure that the Battery Compartment
MIC/INST
switch is set to
Mic
position.
3. Clip the microphone to your clothing (normally Tie or Jacket Lapel). Route
the mic cable so as to avoid undue strain or friction. Try and keep the mic
cable away from the
ANTENNA
The microphone supplied with the S4.4 as a Omni-directional response,
which means it will pick up sounds from all directions. In view of this we
recommend that the microphone is placed as close as possible to the required
sound source.
INSTRUMENT CONNECTION
1. Connect the supplied Instrument cord into the corresponding 3.5mm Top
Panel Socket.
2. Ensure that the battery compartment
MIC/INST
switch is set to
INST
position
BELTPACK GAIN CONTROL ADJUSTMENT
. (Small screw-driver adjust)
If required adjust the Transmitter AF gain control so as the signal only very
occasionally allows the
Red AF O/L Peak Led
on the receiver to light.
CHANNEL SELECTION
(Small screw-driver adjust)
With the Transmitter in the
OFF
position, select a
channel to correspond with the Receiver. It is
possible to select any of the 4 channels.
(
Factory set to position 1
).
Note
: The Transmitter only changes Active
Channel when turned
off
and then
on
.
5
6
ROTATING
BELT
CLIP
BATTERY
STATUS
INDICATOR
BATTERY/
CONTROL
HOUSING
AUDIO
INPUT
ANTENNA
LP2
LAPEL MICROPHONE
ON/OFF
SWITCH
AF GAIN ADJUST
CHANNEL SELECT
MIC/INSTRUMENT SWITCH
S4.4 ARTWORK 17/2/06 11:29 am Page 9
