S4.4 RECEIVER LAYOUT
RECEIVER OPERATION
1. Connect the appropriate AC adaptor into the DC inlet as marked on the
rear panel and observe the Supply indicator (green Led ) lights up.
2. To provide best diversity operation, angle the antennas to form a ”V” as
per illustration and ensure that the antennas have a good line-of–sight
view of the corresponding transmitter. i.e. Avoid placing large metallic
objects in the transmission path.
3. Initially set the receiver AF gain control to its mid-position and connect
the AF output from either the
1/4
inch Jack or XLR to your Mixing console
or amplifier.
4. Select rear panel Channel Selector Switch (Small screw-driver adjust)
to correspond to Transmitter setting. It is possible to select any of the 4
channels. (
Factory set to position 1
).
S4.4 HANDHELD LAYOUT
HANDHELD BATTERY INSERTION
1. Rotate the top collar locking ring in the
direction indicated in the illustration
and gently pull the body downwards.
2. Insert a 9V MN1604 (IEC 6 LR61) PP3 type
alkaline battery, being sure to observe the
correct polarity as marked.
3. Gently slide the body upwards and lock.
Note
: Should the Red battery status Led Indicator go out
during operation, this indicates a flattened battery and
should be changed .
CHANNEL SELECTION
. (Small screw-driver adjust)
With the Transmitter in the OFF position select a channel to correspond with
the Receiver. It is possible to select any of the 4 channels.
(
Factory set to position 1
).
Note
: The Transmitter only changes Active Channel when turned
off
and then
on
.
3
4
DIVERSITY A
ANTENNA A
ANTENNA B
POWER
RF SIGNAL
LEVEL
AUDIO
OUTPUT XLR
AC
ADAPTOR
INLET
CHANNEL
SELECTOR SWITCH
AUDIO
OUTPUT JACK
AUDIO
OUTPUT
LEVEL
MUTE/
SQUELCH
CONTROL
AF PEAK O/L
DIVERSITY B
{
ON/OFF
CHANNEL
SELECTOR
GRILLE
LOCKING RING
ANTENNA
BODY
BATTERY
STATUS
INDICATOR
S4.4 ARTWORK 17/2/06 11:29 am Page 7
