1800 816 277
www.tti.com.au
20
Product HandBook
SuperReel
™
•
Retract a few metres of hose from the SuperReel, to enable testing once the pairing process is
completed.
•
Remove the back cover of the SuperReel by removing the six M6 screws.
•
Lay the back cover down beside the reel, the power supply will still be connected to the reel’s motor.
•
Remove the four screws on the electrical box cover, then unscrew the receiver unit and check that all
switches on the receiver’s 12-way dip switch are set to OFF.
•
Press and hold the program button on the receiver.
•
Press the remote control unit’s button for 2 seconds. The receiver’s LED will flash and then turn
GREEN.
•
Release the buttons on the receiver and the remote control unit.
•
Press the remote control unit’s button to test the receiver’s output. The hose should commence to
wind in.
•
Reinstall the receiver unit, the electrical box cover and the back cover in reverse order to removal.
•
Fully retract the hose onto the SuperReel, allowing enough slack to place the spray gun into its holder.
Figure 8 – SuperReel Remote Control Pairing
