8 - TX ERASURE
IS
-RM4TSUK R
ev
. 2 del 25/10/2011
7 - USABLE TRANSMITTERS
The receiver types SEL2641R433-Z4, can be used with the
following types of transmitters:
!
S2TR2641E2, S2TR2641E2M, S2TR2641E4
!
SETR2641AM2, SETR2641-TM
Single transmitter erasure
Keep the button
P1
pressed down until the first red led
DL
3
switches on ; push the key “A” of the transmitter to cancel : if
this one was stored, it is cancelled: at the end of the
operation both the led
DL3
and
DL4
blink 2 times a to
confirm .
For the erasure of the key “B” of the transmitter push 2 times
P1.
The second position is shown by the flash of the second red
led
DL4;
at this point activate the key “B” of the transmitter to
cancel.
Complete erasure
Keep the button
P1
pressed down until the first red led
DL
3
switches on, release it, push it again and keep it pushed
down until 3 blinks of the red led
DL3
and green led
DL4
occur. In this way the memory is completely cancelled.
9 - MEMORY FULL
In case of full memory, that means
85
transmitters are
already stored, if one try to store an extra transmitter, a
sequence of 3 blinks of
DL3
and
DL4
occurs and the
operation fails.
Notice
Any changes or modifications on equipment not expressly approved by the Transmitter Solutions could void the
user’s authority to operate with the equipment.
GUARANTEE
The warranty period of Transmitter Solutions receivers is 24 months, beginning from the manufacturing date of
the transmitter.
During this period, if the product doesn’t operate correctly, due to a defective component, the product will be
repaired or replaced at the sole discretion of Transmitter Solutions.The warranty does not extend to the receiver
case which can be damaged by conditions outside the control of Transmitter Solutions.
Transmitter Solutions
2505 Chandler Avenue, Suite, 1
Las Vegas, NV 89120 -
(866) 975-0101 - (866) 975-0404 Fax
