background image

TRANSMITTER SOLUTIONS WARRANTY

The warranty period of Transmitter Solutions photo eye is twenty-four (24) 
months. This warranty shall begin on the date the photo eye is manufac-
tured. During the warranty period, the product will be,repaired or replaced 
(at the sole discretion of Transmitter Solutions) if the product does not 
operate correctly due to a defective component. This warranty does not 
extend to (a) the photo eye case, which can be damaged by conditions 
outside the control of Transmitter Solutions, or (b) battery life of the photo 
eye. This warranty is further limited by the following disclaimer of warranty 
and liability:

EXCEPT AS SET FORTH ABOVE, TRANSMITTER SOLUTIONS MAKES NO 
WARRANTIES REGARDING THE GOODS, EXPRESS OR IMPLIED, INCLUDING 
WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICU-
LAR PURPOSE. BUYER MAKES NO RELIANCE ON ANY REPRESENTATION OF 
TRANSMITTER SOLUTIONS, EXPRESS OR IMPLIED, WITH REGARD TO THE 
GOODS AND ACCEPTS THEM “AS-IS/WHERE-IS”. TRANSMITTER SOLUTIONS 
SELLS THE GOODS TO BUYER ON CONDITION THAT TRANSMITTER SOLUTIONS 
WILL HAVE NO LIABILITY OF ANY KIND AS A RESULT OF THE SALE. BUYER
AGREES THAT TRANSMITTER SOLUTIONS SHALL HAVE NO LIABILITY FOR 
DAMAGES OF ANY KIND, WHETHER DIRECT, INCIDENTAL OR CONSEQUENTIAL 
DAMAGES, INCLUDING INJURIES TO PERSONS OR PROPERTY, TO BUYER, ITS 
EMPLOYEES OR AGENTS, AS A RESULT OF THE SALE. BUYER ALSO AGREES TO 
HOLD TRANSMITTER SOLUTIONS HARMLESS FROM ANY CLAIMS BUYER, OR 
ANY THIRD PARTY, MAY HAVE AS A RESULT OF BUYER’S USE OR DISPOSAL OF 
THE GOODS. BUYER HAS READ THIS DISCLAIMER AND AGREES WITH ITS
TERMS IN CONSIDERATION OF RECEIVING THE GOODS.

2480 South 3850 West, Suite B
Salt Lake City, UT 84120
(866) 975-0101 • (866) 975-0404 fax
www.transmittersolutions.com

Summary of Contents for iGAZER32P-10K/NC









Reviews: