Token Ring 2-Port
18
5
Multi-Media Repeater
Powering the Multi-Media Repeater
To power ON the Token Ring Multi-Media Repeater:
1. At Token Ring Multi-Media Repeater back, locate the power
receptacle and associated fuse.
NOTE: Fuse must be installed at correct setting for power source
voltage before connecting to AC outlet.
2. Verify that fuse is installed at correct setting for power source
voltage.
NOTE: The installed fuse rating is indicated by the reading at
lower right corner of fuse holder.
If not installed at correct setting for power source voltage:
•
Carefully open fuse receptacle, using a small flat blade
screwdriver.
•
Rotate fuse holder 180° to the correct rating orientation.
•
Install fuse holder in correct rating orientation.
•
Close fuse receptacle.
3. Plug unit end (female) of power cord into Token Ring Multi-
Media Repeater power receptacle.
4. Plug outlet end (male) of power cord into correct voltage AC
wall socket.
5. At Token Ring Multi-Media Repeater front, verify that POWER
LED is illuminated.
110-120
110-120
220-240
220-240
110-120 Orientation
220-240 Orientation
Fuse Holder
Fuse Holder
2. SITE CONSIDERATIONS
The site for the Token Ring Multi-Media Repeater must provide:
•
AC power outlet for each Token Ring Multi-Media Repeater
•
Adequate ventilation
•
Standard environmental conditions
•
Isolation from electrical noise, including radio transmitters and
broadband amplifiers, motors, high power electrical lines, or
fluorescent light fixtures.
And, if using twisted pair cable:
•
The twisted pair cables should not run in the same conduit with
power line cables,
•
Phone lines should be separated from data cables,
•
Flat or “silver satin” wires should not be used,
•
All Token Ring twisted pair cable should be configured as
straight through.
