Transition Networks
SPS-2460-xx Power Supply User Guide
33455 Rev. B
Page 3 of 9
Required Disconnect
WARNING: A readily accessible, suitable National Electrical Code (NEC) or local electrical code approved
disconnect device and branch-circuit protector must be part of the building's installed wiring to accommodate
permanently connected equipment. Failure to observe this warning could result in an electric shock, even death.
CAUTION: Ensure that the power source is NOT powered ON when connecting it to the SPS-2460-xx external
power supply. Failure to observe this caution could result in damage to or failure of the SPS-2460-xx.
CAUTION: Wear a grounding device and observe electrostatic discharge precautions when installing or servicing
the power supply module. Failure to observe this caution could result in damage to or failure of the power
supply module.
SPS-2460-SA and SPS-2460-PS Differences
The SPS-2460-SA, SPS-2460-CC, and SPS-2460-PS are designed for two different types of media converters. Each
has slightly different dimensions and each has the barrel connector in a different location to ensure that each
power supply is used for the proper application. Note the differences between the devices below.
The
SPS-2460-SA
(shown below) is designed to plug into any style Transition Networks stand-alone media
converter.
The
SPS-2460-PS
(shown below) is designed to mate with Transition Networks stand-alone media converters
3.25” wide
.
Install procedures for both models are provided in the following sections.