8
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
SGPOE10xx-1xx
Cable & Power Connections
CAUTION: Associated Ethernet wiring shall be limited to inside the building. Failure to
observe this caution could result in damage to the connected equipment.
Installing the fiber cable
1.
Locate a 100Base-FX fiber cable with male, two-stranded TX to RX
connectors installed at both ends. See Figure below.
2.
Connect the fiber cables to the SGPOE10xx-1xx media converter as described:
•
Connect the male TX cable connector to the female TX port.
•
Connect the male RX cable connector to the female RX port.
3.
Connect the fiber cables to the other device as described:
•
Connect the male TX cable connector to the female RX port.
•
Connect the male RX cable connector to the female TX port.
Connect fiber cable
to PCM card as shown.
Connect fiber cable
to other Network
device
as shown
RX
TX
RX
TX
[email protected] -- Click the “Transition Now” link for a live Web chat.
9
Cable & Power Connections -- Continued
Installing the copper cable
1.
Locate or build 10/100/100Base-TX copper cables with male, RJ-45
connectors installed at both ends. See Figure below.
2.
Connect the RJ-45 connector at one end of the cable to the RJ-45 port on the
media converter.
3.
Connect the RJ-45 connector at the other end of the cable to the RJ-45 port on
the other device
(wireless access point, VoIP phone, network camera, etc.).
Connecting power
1.
Insert the barrel connector of the power adapter into the power port of the
barrel connector.
2.
Plug the power adapter plug into AC power and the power LED on the front
panel should turn ON.
RJ-45 port
on the other device
(switch, work station, etc.)
RJ-45 port
on the media
converter
Rear View
Power Inlet
