4
SGFEB10xx-12x
24-Hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Installation—continued
AutoCross jumper
The AutoCross feature allows either straight-through (MDI) or crossover (MDI-X)
cables to be used when connecting to 10Base-T, 100Base-TX, or 1000Base-T
devices, such as hubs, transceivers, or network interface cards (NICs). AutoCross
determines the characteristics of the cable connection and configures the unit to
link up automatically, regardless of the cable configuration.
The AutoCross jumper is located on the circuit board of the media converter
(labeled
NA = No Autocross, and A = AutoCross).
See jumper positions below.
Note:
Use small needle-nose pliers to set the jumper.
A
Either straight-through or crossover cable can be
used for all twisted-pair copper links.
NA
Straight-through or crossover twisted-pair cable,
depending on installed site devices, MUST be
installed at EACH twisted-pair copper link.
Note:
Factory default is “A” enabled. Transition Networks recommends leaving
the device in the “enabled” mode.
J6
J6
A
A
NA
NA
SGFEB10xx-12x
[email protected] -- Click the “Transition Now” link for a live Web chat.
5
PWR
LACT
1000Base-X
TX
RX
10/100/1000Base-TX
Use the supplied AC power adapter to power the SGFEB standalone converter. To
connect power to the converter, do the following:
1.
Connect the barrel connector on the power adapter cord to the power connector
on the media converter shown below.
2.
Plug the power adapter plug into AC power.
3.
Verify that the media converter has powered UP—the power LED on the front
panel will be lit.
Port 1: 10/100/1000Base-T
Port 2: 1000Base-X
Power Connector
Standalone Rear View
Installation—continued
Connection power
Port Locations
The drawing below shows the locations of Port 1 and Port 2
The SGFEB10xx-12x models have two ports.
