Transition Networks
SBFTF10xx-10x User Guide
33404 Rev. G
https://www.transition.com
Page 3 of 18
Installation
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when setting the 6-position DIP switch. Failure to observe this
caution could result in damage to the media converter.
Set the 6-position DIP Switch
The 6-position switch is located located on the side of the media converter. Use a small flat blade
screwdriver to set the recessed switches. See below for the locations of the individual switches.
1. TP Auto-Negotiation
up Enables Auto-Negotiation on the copper port
down Disables Auto-Negotiation on the copper port. Forces the setting of switches 2 and 3
2. TP Duplex
(Only functions with switch 1 down)
up Full duplex operation on the copper port
down Falf duplex operation on the copper port
(Parallel detection only with Auto-Negotiation enabled and linked to nonnegotiating device)
up Parallel detects in IEEE standard half duplex
down Non-standard full duplex
3. TP Speed
(Only functions with switch 1 Down)
up 100 Mb/s operation on the copper port
down 10 Mb/s operation on the copper port
4. Fiber Mode
up Forces full duplex operation on the fiber port
down Forces half duplex operation on the fiber port
5. Link Pass Through (LPT)
up Enabled
down Disabled
6. Far-End Fault (FEF)
up Enabled
down Disabled
