Transition Networks
E-TBT-MC05 10Base-T Transceiver User Guide
33406 Rev. C
Page
8
of
14
Connecting to a Device AUI Port
The E-TBT-MC05 can connect to any Ethernet device with an AUI port. To connect to a device with an AUI port,
an AUI cable or direct connection is required. See Figure 7.
Figure 7: E-TBT-MC05 Connected to an AUI Device Port
Connecting to an RJ-45 Device Jack
IMPORTANT: If the transceiver is attached to an Ethernet repeater, a10Base-T hub, or a wiring concentrator, the
SQE test function should be disabled.
To connect the transceiver to a 10Base-T device via RJ-45 jacks, see Figure 8 and do the following:
1.
Select an appropriate length UTP cable for the connection.
2.
Connect one end of the UTP cable to the RJ-45 OUT jack of the transceiver.
3.
Route the free end of the UTP cable to the area where the10Base-T device is located.
4.
Connect the free end of the UTP cable to an RJ-45 IN jack on the 10Base-T device.
Figure 8: E-TBT-MC05 Connected to a RJ-45 Device Jack
