Installing LANMaster T8 on Flat Surface
To install the LANMaster T8 on table, shelf, or other flat surface:
1. Carefully turn LANMaster T8 to side.
2. Install four (4) rubber feet:
•
Remove protective paper from adhesive surface of rubber
foot.
•
Position rubber foot at bottom corner of LANMaster T8.
•
Secure rubber foot to LANMaster T8 surface.
•
Repeat for remaining rubber feet.
3. Return LANMaster T8 to upright position.
8
11
LANMaster T8
8-Port Ethernet Hub w/SIC Slot
Connecting Cable to Slide-In Cards
Connections between installed LANMaster T8 SICs or between a
LANMaster T8 SIC and a hub or terminal device include:
•
Twisted Pair Connector/10BaseT
•
Female AUI Connector/10Base5
•
Male AUI Connector/PC
•
BNC Connector/10Base2
•
Fiber Optic Connector/Fiber Optic.
Twisted Pair Connector/10BaseT Connection
The twisted pair card (E-TBT-SIC) provides an RJ-45 connector to
10BaseT.
To connect 10BaseT Cable to Pocket Hub SIC RJ-45 connectors:
1. Locate or build 10BaseT cables with the following
characteristics:
•
802.3 compliant (See page 18)
•
correct (straight through or crossover) cable configuration
for site installation (See page 7)
•
male RJ-45 plug connectors installed at both ends of cable.
2. Connect male RJ-45 plug connector at one end of 10BaseT
cable to LANMaster T8 RJ-45 jack connector.
3. Connect male RJ-45 plug connector at other end of 10BaseT
cable to DTE terminal RJ-45 jack connector (using crossover
cable orientation) or to Hub RJ-45 jack connector (using
straight through cable orientation).
straight-through
crossover
OR
