Installation
Set the LinkAlert™ switch
The LinkAlert switch is located on the edge of the printed
circuit board and can be easily switched to ENABLE or
DISABLE without the use of tools.
The LinkAlert feature allows the media converter to monitor the fiber and copper
RX
(receive)
ports for signal losses. In the event of a loss of an RX signal, the
media converter will automatically disable the TX
(transmit)
signal, thus “passing
through” the link loss. The far-end device is automatically notified of the link loss,
which prevents the loss of valuable data unknowingly transmitted over an invalid
link.
Note:
If all network devices attached to the media converter(s) are capable of auto-
negotiation, enable the LinkAlert feature on the media converter(s).
Otherwise, disable the LinkAlert feature.
Install the slide-in-module
To install the E-TBT-FRL-N-02 media converter slide-in-module:
1.
Locate an empty slot on the PC workstation or file server.
2.
Remove the screws holding the cover to the slot. Retain the screws.
3.
Carefully slide the slide-in-module into the slot, aligning the module with the
installation guides.
4.
Ensure that the
module is firmly seated in the slot.
5.
Using the screws from step 2, secure the module to the workstation or file
server housing .
E-TBT-FRL-N-02
2
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
4
1
Media
Converter A
Media
Converter B
Near-End
Device
Far-End
Device
original fault
on the copper link
media converter B
disables the copper link
media converter A
disables the fiber TX link
3
2
media converter B
loses the fiber RX link
Installation
-- Continued
Install the copper cable
1.
Use the enclosed 10Base-T compliant copper cable
with male, RJ-45 connectors installed at both ends.
2.
Connect the RJ-45 connector at one end of the cable to
the RJ-45 port on the E-TBT-FRL-N-02 media
converter.
3.
Connect the RJ-45 connector at the other end of the
cable to the RJ-45 port on the other device
(network
interface card (NIC), terminal device, transceiver,
switch, workstation, etc.)
.
Install the copper cable
1.
Locate or build 10Base-FL compliant fiber cable with male, two-stranded TX
to RX connectors installed at both ends.
2.
Connect the fiber cables to the E-TBT-FRL-N-02 media converter as
described:
•
Connect the male TX cable connector to the female TX port.
•
Connect the male RX cable connector to the female RX port.
3.
Connect the fiber cables to the other device
(another media converter, hub,
etc.)
as described:
•
Connect the male TX cable connector to the female RX port.
•
Connect the male RX cable connector to the female TX port.
Power the media converter
The E-TBT-FRL-N-02 media converter is powered by the PCI
(Peripheral
Component Interconnect)
edge connector on the circuit board.
3
[email protected] -- Click the “Transition Now” link for a live Web chat.
Connect the fiber cable
to the media converter
as shown.
Connect the fiber cable
to the other device
(media converter,
hub, etc.)
as shown
RX
TX
RX
TX
RJ-45 port
on the media
converter
RJ-45 port
on the network
terface card (NIC)
E-TBT-FRL-N-02
