4
CVIDF20xx-15x
24-Hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Setting up video system -- continued
To install the video transmitter and receiver system cables, see installation diagram
below.
Point System
Chassis
with
CVIDF20xx-15x
Receiver Card
Fiber
Fiber
Dual Channel Video System
75-Ohm BNC Coax Cable
75-Ohm BNC Coax Cable
Directly Mounted Camera
M
on
ito
r
M
on
ito
r
J/VD-TX-01
Transmitter
Coax*
Camera
Camera
J/VD-TX-01
Transmitter
*75-Ohm BNC Coax Cable
Operation
LEDs
The following shows LED locations and an explanation of each follows:
RX 2
R X1 P WR
1
2
3
[email protected] -- Click the “Transition Now” link for a live Web chat.
5
CVIDF20xx-15x
Operation -- continued
LED
Description
1
RX2
(Receive)
ON solid green = fiber cable connect/receiving data
Off = No power or cable disconnected
2
RX1
(Receive)
ON solid green = fiber cable connect/receiving data
Off = No power or cable disconnected
3
PWR
(Power)
ON Green Powered
OFF No Power
•
Make sure that power is supplied to the transmitter, receiver, and camera,
with the monitor turned ON.
•
The system is operational when the camera feed appears on the monitor.
Cable specifications
Coax cable
RG Type:
RG-59, RG-6
Gauge:
18–25, single conductor
Impedance: 75
ohms
Distance:
228 M
(750 ft)
Max
Fiber
Single Mode
9/125μ
Multimode
62.5/125μ
Multimode
Wavelength:
850 nm
Link Budget:
6.0 db or 11.0 db
Single Mode
Wavelength:
1310 nm
Link Budget:
10.0 db or 15.0 db
Technical Specifications
Use 75-ohm BNC connectors on 75-ohm cable only.
Transition Networks models CVIDF20xx-15x video receiver specifications for
all six models.
Video formats:
NTSC, PAL, SECAM
Video spec
Input Video:
0.5 to 2-volt pk-pk
(75 ohms)
Bandwidth:
5 Hz - 10 MHz
Differential gain:
< 5 %
Differential phase:
< 5°
Tilt: <
1%
Signal/Noise Ratio:
60dB
