2
CVIDF20xx-15x
24-Hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Model
Optic Fiber
Distance
CVIDF2011-150
Video Receiver
(Single)
ST, multimode, 850 nm
1km
(0.6miles)
standard
2km
(1.2miles)
extended
CVIDF2011-155
Video Receiver
(Dual)
(2)ST, multimode, 850 nm
1km
(0.6miles)
standard
2km
(1.2miles)
extended
CVIDF2013-150
Video Receiver
(Single)
SC, multimode, 850 nm
1km
(0.6miles)
standard
2km
(1.2miles)
extended
CVIDF2013-155
Video Receiver
(Dual)
(2)SC, multimode, 850 nm
1km
(0.6miles)
standard
2km
(1.2miles)
extended
CVIDF2012-150
Video Receiver
(Single)
ST, single mode, 1310 nm
10km
(6.2miles)
standard
20km
(12.4miles)
extended
CVIDF2012-155
Video Receiver
(Dual)
(2)ST, single mode, 1310 nm 10km
(6.2miles)
standard
20km
(12.4miles)
extended
Connector Type
Quantity
Distance
75-Ohm BNC
2
75-Ohm coax cable, 228m
(750ft)
Fiber
2
Model dependent
(see below)
The video receiver system has the following types of connectors.
The various fiber connections are available on separate models. Single mode and
multimode receivers come in the following configurations.
Installation
Card handling
1. Keep the CVIDF20xx-15x card in its anti-static bag until ready to install.
2. Wear a grounding strap when removing the card from its anti-static bag.
Distance configuration shunt
The CVIDF20xx-15x card come with a shunt installed in the “S” position on connector
J1
(single channel)
and J1/J5
(dual channel)
as shown below.
CVIDF20xx-15x
Installation -- continued
J1 and J5 are distance configuration connectors. Position “S” is for standard distances
and “X” is for extended distances. The distances are model dependent.
Installing video card in a Point System chassis
To insert the video card, do the following:
1. Wearing a ground strap, slide the card into an available slot in the Point System
chassis. See photo below.
2. Push the card all the way into the slot
(should snap in)
.
3. Push in and turn the screw clockwise to secure the card to the chassis frame.
3
Setting up the video system
Equipment needed:
•
J/VD-TX-01 fiber transmitter
(single or multimode)
•
CVIDF20xx-15x video card
(single or multimode)
•
Video camera
•
Monitor
•
Coax cable
•
Fiber cable
Note:
The video transmitter and receiver must be matched: single mode TX/RX or
multimode TX/RX. If installed as a mixed pair, the system will not function.
Caution:
Use 75 ohm BNC connectors on 75 ohm cable only. Failure to observe this
caution will result in signal degradation.
Note:
See J/VD-TX-01 fiber transmitter manual
(#33349)
available on the web @
transition.com for specifics.
[email protected] -- Click the “Transition Now” link for a live Web chat.
