Transition Networks CFETF1011-205, User Manual

Page: 8 / 8

CFETF10xx-205
8
24-hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 techsupport@transition.com -- Click the “Transition Now” link for a live Web chat.
9
Cable Specifications
Copper Cable
Category 5:
(minimum requirement)
Gauge 24 to 22 AWG
Attenuation 22.0 dB /100m @ 100 MHz
Maximum Cable Distance 100 meters
• Straight-through or crossover twisted-pair cable may be used.
• Shielded twisted-pair or unshielded twisted-pair may be used.
• Pins 1&2 and 3&6 are the two active pairs in an Ethernet network .
• Use only dedicated wire pairs for the active pins:
(e.g., blue/white & white/blue, orange/white & white/orange, etc.)
• Do not use flat or silver satin wire.
Str ai g h t -Th r ou g h Cable C r o ss ove r Cable
Twi st e d Pai r #1
Twi st e d Pai r #2 Twi st e d Pai r #2
Twi st e d Pai r #1
Operation
-- Continued
SUMP
See the on-line documentation that comes with Transition Networks
FocalPoint™ software for applicable commands and usage.
Use SUMP at an attached terminal or at a remote location to monitor the
following media converter activities:
• Media-converter power
• Copper link and fiber link status
• Twisted-pair cable length
• Hardware switch settings
• Fault condition
Also, use SUMP to enter network commands that:
• Enable/disable full-/half-duplex
• Enable/disable Link Pass-Through (LPT)
• Enable/disable Far-End Fault (FEF)
• Enable/disable Pause
• Enable/disable AutoCross
• Power down the media converter