Transition Networks
C4110 Install Guide
33572 Rev. B
https://www.transition.com/
Page 8 of 33
DIP Switch (SW1) and
Jumper (J9)
The C4110 has a field-configurable DIP Switch (SW1) and Jumper (J9) as shown below.
Figure 4. Jumper J9 and DIP Switch SW1
Hardware/Software
Mode Jumper (J9)
The hardware/software 3-pin header, J9, is located on the circuit board
(labeled
S
and
H
).
Use a small needle-nose pliers to set the jumper.
S - Software
In this position, the mode of the C4110 is determined by the
most-recently saved software settings. This is the default
setting.
H - Hardware
In this position, the mode of the C4110 is determined by the
8-position DIP switch (hardware) settings.
Note
: you must change the J9 setting to
H
(Hardware mode) to be able to use the DIP Switch settings
(see below).
Use the CLI command “
show card info
” to show the current Config mode setting (
hardware
or
software
).
From the web GUI, navigate to the ION Stack > Chassis > C4110 menu path and check the MAIN tab’s
System Configuration section > Configuration Mode field setting (i.e.,
hardware
or
software
).
