Transduction TR-5190-PM, User Manual

Page: 26 / 108

CPU Installation
The TR-979 Industrial SBC Card provides a 478-pins ZIF socket
for Pentium 4 processors with FC-PAG2 package.
To Install a CPU, first turn off your system and remove its cover. Locate
the ZIP socket and open it by first pulling the lever sideways away from
the socket then upwards to a 90-degree right angle. Insert the CPU with
the correct orientation. Use the notched corner of the CPU with the white
dot as your guide. The white dot should point towards the end of the
lever. Notice that there is a blank area where one hole is missing from
that corner of the square array of pin holds. Because the CPU has a
corner pin for three of the four corners, the CPU will only fit in one
orientation. With the added weight of the CPU fan, no force is required
to insert the CPU. Once completely inserted, hold down on the fan and
close the socket lever.
To disassembly the processor, simply pull the lever sideways away from
the socket then upward to a 90-degree right angle. You can take the CPU
out from the socket without help of any tool.
After installing the processor into the Socket, ensure that the CPU fan is
installed first. Without a fan circulating air on the CPU, the CPU can
overheat and cause damage to both CPU and SBC card.
WARNING!:
If no FAN circulating Air on the CPU, the processor
might been overheated and damage both CPU and SBC components.
IMPORTANT:
You must set jumpers for “CPU FSB speed” depending
on the CPU that you install.
22 TR-5190 User Manual