Transducer Techniques LCA-9PC, Operator'S Manual

Page: 7 / 18

-
7-
Pin 6 GND
Pin 5 11.8-26V
Pin 4 GND
Pin 3 V
o
Pin 2 GND
Pin 1 I
o
Pin 1 -EXC
Pin 2 -SEN
Pin 3 -SIG
Pin 4 +SIG
Pin 5 +EXC
Pin 6 +SEN
Pin 5 GND
Pin 4 11.8-26V
Pin 3 V
o
Pin 2 GND
Pin 1 I
o
Pin 1 -EXC
Pin 2 -SEN
Pin 3 -SIG
Pin 4 +SIG
Pin 5 +EXC
Pin 6 +SEN
ELECTRICAL CONNECTIONS
Model LCA-RTC (with removable terminal connectors)
Revisions G and later:
Terminal Connector J1
(bottom of product label, sensor side)
Terminal Connector J2
(top of label, signal output & power side)
Revision G was implemented in July 2017 for the LCA-RTC to change the green power
connector from 3 pins to 2 pins, and to increase the pitch (or spacing) between the
power connecter pins. In combination, these two changes minimize the chance of
applying power to the wrong terminals, thereby damaging the unit. LCA-RTC cable
assemblies built for Revision F or earlier units cannot be used with Revision G or later
units.
Revisions earlier than G:
Terminal Connector J1
(bottom of product label, sensor side)
Terminal Connector J2
(top of label, signal output & power side)
WARNING: If input power (green connector) is plugged into the black terminal
(jacks 1, 2, 3), damage will occur to the device.