Transcend TS-UWE31, User Manual

Page: 16 / 65

12
HARDWARE INSTALLATION
IDE Connectors
D I M M 1 ( 6 4 b i t 1 6 8 p i n S D R A M M o d u l e )
D I M M 2 ( 6 4 b i t 1 6 8 p i n S D R A M M o d u l e )
PCI Slot1 (PCI1) PCI Slot2 (PCI2) PCI Slot3 (PCI3)
PS/2
T:MouseB:Keyboard
USB
T:Port 1B:Port 2
ATX Power Connector
KB MOUSE USB
POWER-FAN
CPU-FAN
KB-AWK
WOL
Panel Connector
CASE-FAN
CMOS-CLR
IrDA
FDC
IDE2
IDE1
JP5
GMCH
COMB
JP2
FWH
JP6
A C 9 7
AMR
G a m e P o r t
L i n e _ i n
M I C
IntelICH
TS-UWH31
Winbond 83627
CD2
CD1
MODEM
Intel
COMA
VGA
P a r a l l e l P o r t
Li Battery
VIDEO
AUX
L i n e _ o u t
66/100MHz
Pin1
Transcend
Primary IDE Connector
(Blue color)
Second IDE Connector
(Black Color)
IDE1
IDE2
PIN1
PIN1
IDE Connector
2.7 Primary / Secondary IDE Connectors (Two 40-1-pin IDE)
This motherboard supports two 40-pin IDE connectors marked as IDE1 (primary channel)
and IDE2 (secondary channel). Each channel supports two IDE devices, making a total of
four devices.
Connect your Hard Disk (the main one if you are using more than one) to the “Master” connector
(at the end of the cable) and connect it to the IDE1 (see important note below). If your HDD
supports Ultra DMA/66, you must use an 80-wire cable, otherwise the HDD won’t be able to
reach this speed.
If you intend to operate two IDE devices from the same channel, one device must be set to
“master” mode, the other to “slave” mode. A Hard Disk, CD ROM or other IDE device can
have either setting, depending on device’s jumper. Please refer to the device’s manual for
more information.
NOTE:
The Connectors must be attached to the IDE channels the right way round. Make
sure that the red stripe on one edge of the ribbon cable (this may be faint and could
also be a dotted line) is the nearest to PIN 1 (on the left as the motherboard is shown
in the picture below).