6
Installing a Hard Drive
Installing a Hard Drive
If you purchased a StoreJet
™
2.5 that does not have a Hard Disk Drive already installed, please read this
section, otherwise you can skip to the “
Driver Installation
” section.
1.
Open the StoreJet
™
2.5 by removing the two screws from either side of the top cover, as indicated in
the diagram.
Figure 2. Remove the screws from the top cover
2.
Remove the cover revealing a control board adapter; this converts the SATA interface connector of the
hard drive to a Mini USB 2.0 interface. Slide out the control board.
Figure 3. Remove the top cover revealing the SATA adapter
3.
Carefully line up and plug in the SATA connector on the control board to the hard drive. Do NOT force
the SATA connector into the hard drive and do NOT insert the connector at an angle, otherwise you
may damage it.
In
s
ta
ll
in
g
a
H
a
rd
D
ri
v
e
