The power terminal, Analog Signals output and Communication
port locate the upper of the display, mark J2. Total 8 connect
terminals. Use slotted screwdriver clockwise tension.
Follow is the definitions of the connect terminals:
Maker Definition
Description
P+
Positive for DC Power
P-
Negative for DC Power
DC 15V
±
10%, 500mA
Note: Please connect
Power +/- correct.
+24 Analog
Single
( 0-10V/4-20mA) drive
power+ ( Exterior power)
Power standard: DC 15~24V
If using this power supply
to analog single current,
please open J3.
0
Common port
a. Analog single drive power-
b. With I
o
or V
o
compose
signal loop.
I
o
4-20mA output Single
With Common port compose
signal loop.
Output range: 0~24mA
V
o
0-10V output Single
With Common port compose
signal loop.
Min. load resistance: 10K
Ω
AA RS485
in-phase
input/output
BB RS485
re-phase
input/output
When several TI-1500VC
are in one network, the last
TI-1500VC’s J4 should be in
short circuit, RS-485
terminal resistance is
enable.
-3-
3. TI-1500VC Setup Menu
3.1 System menu (F menu)
The section provides more detailed descriptions of the selections
found in the system menu chart (F menu).
Factory-set (F21) defaults are shown in bold with a checkmark (
√
).
F menu
Name/Code
Description Code/Value
F1
Graduation
Specifies number of full-scale
graduations. Value should be
consistent with legal require-
ments and environmental limits
on the useful system resolution.
500 1000
1500 2000
2500 3000
4000
5000
√
6000 8000
10000 12000
20000 30000
40000 50000
F2
Span Gain
Span Gain is related to A/D
integration time. The larger the
span gain, the higher the internal
resolution, but the slower the
update speed. Note that the scale
must be re-calibrated whenever
this parameter is altered. See
Appendix C for more information.
25 50
75
100
150
√
200
F3
Zero Track
Band
Selects the range within which
the scale will automatically zero.
Note that the scale must be in
standstill to automatically zero.
Selections are in Display
Divisions.
OFF
√
0.5d 1d 3d
4d 5d 6d
7d 8d 9d
-4-