9
Calibration - Continued
6. Press the ENTER (Yes) key to save the 4 lb calibration value. The SPS-30 Plus scale
displays the message “C 30 “.
7. Place the 30 lb test weight(s) onto the scale’s platter. When the weight stabilizes, the
scale displays the message “ PR ENTER”.
8. Press the ENTER (Yes) key to save the 30 lb calibration value. The scale then dis-
plays the message “Calibration End”.
9. Turn OFF the scale then turn back ON to resume normal operation.
Changing the origination ZIP code setting:
If you change locations or just simply notice at start-up that your origination ZIP code is not set
correctly, you may re-program it by performing the following steps:
1. Press and hold the ZERO key while turning on the scale. When the message “ZIP Code
OK?” appears on the screen, you may release the ZERO key. The scale prompts ” ZIP
Code OK?” and displays the current ZIP code.
2. Press the ENTER (Yes) key to accept the displayed ZIP code or press the CLEAR (No)
key to change the ZIP code.
•
Note:
If
“Yes”
is selected, the scale exits back to normal operating mode. If
“No”
is
selected, the message “Input ZIP = ???” appears in the display.
3. Using the numeric keys, enter the first three digits of the ZIP code you will be mailing
from. Once all three digits are entered, the scale prompts ” ZIP Code OK?” and displays
the current ZIP code. Repeat Step 2.
Error Messages
Message
Explanation
ovwt
Indicates that the weight for the class of service se-
lected has been exceeded
OVERWT
Indicates that the weighing capacity of the scale has
been exceeded
– – – – – – –
Indicates that the weight reading is less than zero
Invalid Zip Code
Invalid Zone #
Indicates that an invalid ZIP code or zone was en-
tered
Invalid Cty Code
Indicates that an invalid country code was entered
Service N/A
Indicates that the extra service is not valid for the
class of mail selected
Invalid Service
Indicates that the extra service is not valid with the
current extra service(s) selected.
