LT-9065 Installation Quick Start Guide Revision A
3
1.
Feed the U-bolts through the mounting
brackets and then through the back plate
before securing using the hex nuts.
Getting Altum AC Ready for Power Up
3.
Plug in The Ethernet cables and install them
into the port plug as shown.
Note: The LAN port is on the “right” side as
you look into the unit, while the WAN port is
on the “left”
4.
Install the Port Plug as seen below.
5.
Feed the Ethernet cable(s) through and
attach the Port Plate using the (2) captive
screws. Tighten until snug.
6.
7.
Plug the Ethernet cables into the POE
injector power supply as shown below.
Note: the POE and LAN ports are also
labeled on the power supply.
U-Bolt
U-Bolt
Bracket
Hex Nut
Port Plug
Ethernet Cable
Port Plug
Port Plate
Captive Screw
