Failure to follow instructions below could result in death
or serious injury.
• All Ingersoll Rand personnel must follow Ingersoll
Rand Environmental, Health and Safety (EHS)
policies when performing work such as hot work,
electrical, fall protection, lockout/tagout, refrigerant
handling, etc. All policies can be found on the BOS
site. Where local regulations are more stringent
than these policies, those regulations supersede
these policies.
• Non-Ingersoll Rand personnel should always follow
local regulations.
WARNING
Follow EHS Policies!
Copyright
This document and the information in it are the property of
Trane, and may not be used or reproduced in whole or in part
without written permission. Trane reserves the right to revise
this publication at any time, and to make changes to its content
without obligation to notify any person of such revision or
change.
Trademarks
Revision History
All trademarks referenced in this document are the
trademarks of their respective owners.
Introduction
3
Summary of Contents for CLCP Euro 25
