Figure 75:
Door
‚
closed
’
and
‚
locked
’
Figure 76:
Delivery of the keys
Abovementioned doors with lock are an effective safety device according to EN ISO 12499: there
is no case where entering during fan operation is required, refer also to
chapter 2.2 (Indications
for minimizing specific hazards)
.
The locking mechanism of the hinged door is on the inside of the door panel and is shown in
(closed position) and
(open position). The rolling piston can be pressure from
above (if you are in the unit) with your thumb in the position 'open'.
Figure 77:
‚
Closed
’
Figure 78:
‚
Open
’
Readjustment of the door panel position
Because of the handling of AHU sections, the position of the door panel can move (see
).
Due to the inclination of the door panel of the EU hinged doors, problems can arise when closing
and sealing of the door panel. The door panel can be readjusted through the screws on the hinges.
For this purpose, first the screws on the hinge (
) must be loosened. Then, the door panel
can be brought in the correct position (
) and the screws can be tightened again.
Figure 79:
Inclined door panel
–
varying slit width
Figure 80:
Adjustment of the door
panel
Figure 81:
Adjusted
– constant slit
width
If the above described readjustment of the door panel is not sufficient, then unevennesses in the
erection are the cause and must be appropriately corrected.
Summary of Contents for CCEB
Page 48: ...Figure 83 Pulling out the filters Figure 84 Pull out tool...
Page 74: ......
