Trane
www.trane.com
01/10
Trane
has a policy of continuous product and product data improvement
and
it reserves the right to change
design and specifications without notice.
Installer’s Guide
INDOOR THERMOSTAT
SWITCH SETTING
1
1
Fan Switch
TO CHECK
Off
Cool
Heat
Auto
On
COMPONENT OPERATION
Indoor
Outdoor
Compressor
3
Comp.
Furnace
Blower
Fan
Runs
Sump
Heat
Runs
Runs
Heater
Comes On
Step
No.
CHECKOUT PROCEDURE WITH MAIN POWER DISCONNECTS CLOSED (ON)
1
Also set thermostat dial to call for cooling or heating as necessary.
2
Check only necessary if heating unit is used for indoor section and wiring has been disturbed during installation of cooling equipment.
3
When applicable.
1
Sump Heat
X
X
X
2
Indoor Fan Operation
X
X
X
X
3
Cooling Operation
X
X
X
X
X
X
4
Checking Performance
X
X
X
X
X
X
& Charge
USE CHARTS ATTACHED TO O.D. UNIT
5
Heating
2
X
X
X
X
X
6
Inform owner on how to operate system and what to expect of it. At the same time deliver Owner’s Use and Care Booklet.
CHECKOUT PROCEDURE
After installation has been completed, it is recommended that the entire system be checked against the following list:
1. Refrigerant Line, Leak checked .................................. [
]
2. Suction Lines and Fittings properly insulated ........... [
]
3. Have all Refrigerant Lines been secured and
isolated properly? ........................................................ [
]
4. Have passages through masonry been sealed?
If mortar is used, prevent mortar from coming
into direct contact with copper tubing ........................ [
]
5. Verify tightness of all electrical connects ................... [
]
6. Observe outdoor fan during on cycle for clearance
and smooth operation .................................................. [
]
7. Indoor coil drain line drains freely. Pour water
into drain pan .............................................................. [
]
8. Supply registers and return grilles open and
unobstructed ................................................................ [
]
9. Return air filter installed ............................................ [
]
10. Thermostat thermometer is accurate. Check
against a reliable thermometer. Adjust per
instructions with thermostat ...................................... [
]
11. Is correct speed tap being used?
(Indoor blower motor) .................................................. [
]
12. Operate complete system in each mode to
insure safe operation. .................................................. [
]
