TEF 9964
XENON HELIDECK FLOODLIGHT INDUSTRY USER MANUAL
INTRODUCTION
Thank you for purchasing this product!
For installation, maintenance and assurance of a long life
of this product, please follow this manual.
CONTENT IN BOX
The product is fully assembled, and ready for installation.
SAFETY PRECAUTIONS
Note that changes made to the product and/or installation
of components which do not conform to the approval,
may be a safety violation. The manufacturer will in no
circumstance be held responsible for such activity.
For your health and safety, always use safety gear suited
for the task. Be certain to follow codes, regulations and/or
specific procedures that are related to the installation.
TOOLS REQUIRED
Regular tools required for installation:
•
17 mm wrench –for assembling the floodlight.
•
13 mm wrench –for adjusting the angle of the light.
•
8 mm flat screwdriver –for open/closing the cover of the
junction box.
•
3 mm flat screwdriver –for installing the cable in the
terminal block.
•
5,5 mm flat screwdriver –for removing the lamp insert.
•
32 mm wrench -to assembly the cable gland
•
30 mm wrench -to tighten the lock nut and the pressure
nut
MAINTENANCE INSTRUCTIONS
The luminaire should be inspected according to Company
routines. The manufacturer suggests regular check for
water intrusion/condensation which should be removed
immediately. Check the drain plug / drain hole function.
When cleaning, use only mild detergents. Alcohol or
petroleum based products may damage lens, paint or
plastic components.
RUBBER SEAL
Cable diameter
Size rubber seal
Part No. Cable gland kit
11,0 - 15,0 mm
Ø26/15,0x10mm
622 2502
15,0 - 20,1mm
Ø26/20,3x10mm
622 2502
Be sure to install the cable in a way wich prevents water to penetrate into the enclosure through the cable gland,
also make sure to use the correct rubber seal when you install the luminaire
APPLICATIONS
•
Floodlighting of helicopter landing areas
•
For use safe area
•
Floodlighting
