TEF 1058-5 EASY ACCESS
HEAT TRACE JUNCTION BOX
INTRODUCTION
Thank you for purchasing this product!
For installation, maintenance and assurance of a long life
of this product, please follow this manual.
MAINTENANCE / REPAIR / MODIFICATION
Maintenance according to national regulations and
company practice.
Before opening the junction box make sure that the power
is disconnected.
Servicing the junction box is done by checking the
intactness of the junction box, gasket and glands. If
necessary lubricate the lid bolt threads with grease type
Renolit Unitemp 2 from Fuchs.
If repair or overhaul is necessary, only Tranberg spare parts
must be used.
Modification of the JB or change of design are not
permitted, except for installing additional glands according
to the approval of the JB.
While unpacking the the product, please ensure that no
loose items are lost. Inspect the exterior of the product
for any transport damages and/or other defects. When
opening the junction box, remove any foreign objects
that may have been inserted for transportation and/or
preservation purposes. If the product is to be repacked
and kept for storage, replace any such preservation
component(s).
Damages due to transportation is not the responsibility
of the manufacturer. If the contents is not complete or
the product does not work at intended, file a claim to the
supplier or manufacturer immediately.
UNPACKING AND INSPECTIONS
SAFETY INSTRUCTION
Changes made to the product not confirming to the
approvals of this equipment, is a safety violation.
The manufacturer is under no circumstances responsible
for personal injuries, death or any other damage caused
by such activities.
For replacement and repairs of the terminal/junction box,
only Tranberg AS spare parts may be used.
Repairs effecting the explosion protection of the
equipment, may only be carried out by Tranberg AS, or
qualified electricians in compliance with the respective
national regulations.
The product should be stored in the original packing
material, in a dry location and within the operational
temperature range. The product may have been equipped
with plastic plugs instead of, or in addition to cable glands,
and these should be left as they are until cable glands are
to be installed.
STORAGE AND PRESERVATION