TRAMONTINA PRESSURE COOKER |
USER MANUAL
15
WARRANTY
The TRAMONTINA Pressure Cooker has a 5 year warranty against material &
manufacturing defects. The warranty only covers the body. It does not cover parts of the
pressure cooker which are subject to wear (eg - rubber gasket, O-ring for Safety Valve
or any other spare part). Improper use will result in cancellation of the warranty. The
warranty will only be considered valid if the product is used in accordance with these
Use & Care Instructions and upon presentation of a dated proof of purchase.
Note:
If you are unable to solve a problem or correct a defect, please contact Tramontina Customer Service for further
guidance on 1800 110 885 or +61 2 9674 1799 if outside Australia.
Use only the appropriate spare parts for the TRAMONTINA pressure cooker available at www.tramontina.com.au.
TROUBLE SHOOTING
Symptom
Cause
Solution
No steam escapes
from the pressure regulator
There is not enough liquid in the
cooker
Add at least the minimum amount
(0.25 litre) of liquid
Steam escapes around the pressure
regulator
This is normal, however, if a very large
amount of steam escapes, you should
reduce the temperature
Turn down the heat and then continue
cooking as usual Decrease the quantity
of liquid as per the instructions
A lot of steam leaks from the pressure
indictor valve
The O-ring for the pressure indictor
valve is not installed properly
Install the O-ring properly in the groove
Steam escapes at the
edge of the lid
The rubber gasket is not properly in
place The rubber gasket is dirty or
damaged
Insert the gasket properly.
Clean and replace the gasket.
The indicator rod
does not rise
- The heating temperature is too low
- The cooker is not closed properly
- There is not enough liquid in the
cooker.
- The rubber gasket is damaged or
hardened.
- The pressure regulator is not attached
correctly and firmly
- Increase heat.
- Close the cooker properly by making
sure the push plate is in the locking
position.
- Add at least the minimum amount
(0.25 litre) of liquid
- Replace the gasket
- Insert the pressure regulator correctly
and select a pressure setting. (Page 12)
The indicator rod does not go down
There is still pressure built in the
cooker.
Wait until the pressure releases from
the cooker and turn the pressure
control device to steam releasing
setting.
Opening and Closing system does not
work.
The mark on the lid does not align
with on the long handle.
Make them align by making sure the
push plate is in the locking position.
