14
!
!
!
!
English
ASSEMBLY OF EQUIPMENT
To prevent serious personal injury, stop the engine and allow the impeller to stop before attaching or
removing tubes.
To prevent serious personal injury or damage to the unit, make sure the blower tubes, or vacuum tubes
and the vacuum bag, are in place before you operate the unit.
Blower assembly
Installing the Upper Blower Tube:
1.
Align the bump on the end of the upper blower tube with the bump slot on the bottom end of the blower outlet.
2.
Insert the upper blower tube into the blower outlet.
3.
Twist the upper blower tube clockwise until it locks into place (Fig. 01, Pag. 04).
Installing the Lower Blower Tube:
1.
Align the bump slot on the top end of the lower blower tube with the bump on the end of the upper blower tube.
2.
Place the lower blower tube onto the upper blower tube.
3.
Twist the lower blower tube clockwise until tight (Fig. 02, Pag. 04).
Removing the Upper Blower Tube:
1.
Hold the unit firmly.
2.
Insert a flathead screwdriver into the tube lock. Twist the screwdriver counterclockwise 1/4 turn and hold.
3.
Grasp the upper blower tube and twist it counterclockwise.
4.
Pull the upper blower tube from the blower outlet (Fig. 03, Pag. 04).
Removing the Lower Blower Tube:
1.
Hold the upper blower tube firmly.
2.
Grasp the lower blower tube and twist it counterclockwise until the lower blower tube unlocks from the upper
blower tube.
3.
Remove the lower blower tube from the upper blower tube.
Vaccum Assembly
Installing the Vacuum Tubes:
1.
Locate the hole in the impeller door. The door lock tab is recessed in the hole toward the front of the blower. Insert a
flat head screwdriver, into the hole and press the door lock tab in and lift the door to release the lock (Fig. 04, Pag. 04).
2.
While holding the impeller door open, align the upper vacuum tube’s three (3) slots with the impeller intake’s three
(3) lock tabs (Fig. 05, Pag. 05).
3.
Insert the upper vacuum tube into the impeller intake and twist the upper vacuum tube clockwise with both hands
until the lock tabs snap into place (Fig. 06, Pag. 05).
3.
Align the arrow on the lower vacuum tube with the arrow on the upper vacuum tube. The arrows must align properly
to install the vacuum tubes correctly (Fig. 07, Pag. 05). Grasp the lower vacuum tube firmly with both hands and push
the lower vacuum tube into the upper vacuum tube. Turn the lower vacuum tube clockwise until it snaps into place and
locks. The dot on the lower tube aligns with the dot on the upper tube when properly assembled.
Use both hands during this assembly to fit the parts together tightly.
The flat area on the upper vacuum tube should face the handle when installed correctly.
Vacuum Bag Assembly
Installing the Vacuum Elbow onto the Blower:
1.
While facing the front of the unit, hold the keyed end of the vacuum elbow in the left hand and the flared
end in the right hand. Align the lock tabs on the keyed end with the lock tabs on the blower outlet.
2.
Insert the vacuum elbow into the blower and turn clockwise until it locks into place (Fig. 08, Pag. 05).
