TRAK Machine Tools
Site Preparation Guide
TRAK DPMRX5
F16467-46 Rev 062518
Page 1 of 4
Before an Authorized Field Service Technician can perform the machine’s final checkout, the following requirements must be met:
The machine must be in position and placed on its rest pads
To offload the machine, a 6000 lb. forklift with 6’ extension is required.
The machine must be leveled (refer to installation and service manual).
The machine must be wired (refer to the installation and service manual).
The machine must have air hooked up if power drawbar is installed (see the
installation and service manual).
The machine must be cleaned. Remove all grease from the way surfaces.
Space & Weight
•
Floor area = 131.0625”x103”
•
Height = 102”
•
Footprint = 24”x48.4”
•
Net (approx.) Weight = 4400 lbs.
•
Shipping (approx.) Weight = 4600 lbs.
•
Pallet Size = 76”x76”, 8” thick
•
Allow clearance at the rear of the mill to open and work
on the electrical box.
•
A solid and level foundation to maintain approximately
4400 lbs plus the weight of the workpiece (maximum
total 6200 lbs) is required. Six leveling screws are
provided.
Electrical
•
Machine is only available in the 208 VAC configuration
(200 to 240V is acceptable). A separate 208V, 35 amps,
60 Hz, 3 phase circuit is required. For shops with 440
VAC, a step-down transformer to 208 VAC must be used.
The transformer must be sized to carry a load of 35
amps minimum.
•
Machine tool must be earth grounded.
Air (for optional Power Drawbar)
•
¼” NPT connection
•
Air pressure not to exceed 100 psi
•
17.5 SCFM or 2.5 CFM at 90 psi
DPMRX5 Machine Footprints
A
Overall Width
131.0625”
B
Overall Length
103”
C
Bed Width
24”
D
Bed Width between leveling screws
21.7”
E
Distance between leveling screws
20.5”
F
Bed length
48.4”
