Chain connecting link
Front assembly completed, prior to
chain adjuster being tightened
5.
Chainguard:
Install the chainguard using the first and third hole from bottom in the
front and the hole on the fender brace in the back. Tighten down with the matching
nuts and make sure that the chain does not rub anywhere on the chainguard. Adjust as
necessary.
Front chainguard installation
Rear chainguard installation
6.
Backrest:
Insert backrest onto front frame assembly with pivot mounting tub pointed
downwards and to the rear. The backrest should slide evenly onto the frame about 1.5”
to 2” on both sides. Note: This may be a tight fit and it may be necessary to lubricate the
frame and tap the backrest on with a rubber mallet. Insert bolts into the backrest
clamps from the outside and loosely install washers and nuts. Note: On some backrest
clamps, it may be necessary to squeeze with pliers before inserting screws.
