www.TrailFX.com
Page
3
of
4
Rev122716
5.
From under the vehicle, place the driver’s side Fog Light Guard into the Fog lamp opening on the back side of the bumper.
The Bars on the Fog Light Guard should be in the vertical position (Fig 5).
6.
A helper can be handy to hold the Fog Light Guard in place (Fig 7), Carefully re-install the Fog Lamp housing into the
bumper using the original Phillips head screws. Snug the screws (Fig 8) and the Fog Light Guard will be held in position
be-tween the light housing and the bumper itself. With driver side now complete, please repeat all steps for the passenger
side Fog Light Guard.
Caution:
At this point the Fog Light Guards are installed. After installing any other nearby Light-Guards, re-install the Plastic factory Air
Dam.
Care and Maintenance: Your Light-Guards have been designed and manufactured to provide years of use. However, like any
product general maintenance is required to keep them looking new. Since the Light-Guard is located on the front of the vehicle,
it is subject to potential rock chips and other debris potentially causing portions of the paint to chip off.
For Textured Finish Light-Guards: We recommend using a textured spray paint sprayed on a piece of cardboard and Q-Tip to
gently fill in these chips. This will prevent any rust from forming.
