www.TrailFX.com
Page
2
of
4
Rev122716
1.
Put on safety glasses. For easy access to the Fog Light housings, remove the factory plastic air dam. Start by unscrew-ing the
plastic phillips head screws and removing plastic rivets. These are located on the underside of bumper and backside of
cross member as shown in figures 1 & 2. Remove air dam and save all screws & rivets for reinstallation.
2.
Removing the Fog Light: Starting with the Driver’s Side, Locate the back of the driver side Fog light by looking under your
vehicle on the back of the bumper (Fig 3). On the back of the Fog lamp housing are four (4)Phillips head screws that secure
the housing to the bumper.
3.
From under the vehicle, remove these screws using a Phillips head screwdriver (fig 3) and set them aside in a safe place for
re-installation.
4.
Place/install the enclosed O-Rings on the outside of the Fog Light Guard as shown in Fig 4. The O-Ring should be on the face
of the Euro Guard that will be in contact with the bumper housing.
